Euro 5 / PassThru
Control unit diagnosis and reprogramming through Euro 5 / PassThru with the vehicle manufacturer's data
Use of PassThru in the workshop
To use the online portals of the vehicle manufacturers, it is necessary to have a communication module such as the new KTS generation with PassThru interface to SAE J2534. With the Bosch PassThru software and the software from the respective vehicle manufacturer, it is possible to use the original information from the manufacturer for diagnosis in independent workshops.
Information on all KTS products
Ford models that comply with the Euro 5 Standard may use PassThru with the KTS; however, there are limitations with older vehicles that use the old vehicle protocol SAE J1850 with a programming voltage.
Information regarding KTS models: KTS 530, KTS 540 and KTS 570.
Information on reprogramming
Please also refer to the manufacturer's information.
Manufacturer Portal
Chevrolet
Ford
PDF in preparation
Land Rover
PDF in preparation
Lexus
Seat
PDF in preparation
Škoda
PDF in preparation
Toyota
PDF in preparation
Volvo
PDF in preparation